hysol® product e-60hp
product description
loctite® hysol® product e-60hp is a toughened, mediumviscosity, industrial grade epoxy adhesive with extended work life. once mixed, the two-component epoxy cures at room temperature to form a tough, off-white, bondline which provides high peel resistance and high shear strengths. the fully cured epoxy is resistant to a wide range of chemicals and solvents, and acts as an excellent electrical insulator.
typical applications
the high performance epoxy provides excellent bond strengths to a wide variety of plastics and metals. ideal for general purpose industrial applications requiring extended work life for adjusting parts during assembly.
properties of uncured material
general information
this product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials.
for safe handling information on this product, consult the material safety data sheet, (msds).
directions for use
1. for high strength structural bonds, removal of surface contaminates such as paint, oxide films, oils, dust, mold release agents and all other surface contaminates.
2. use gloves to minimize skin contact. do not use solvents for cleaning hands.
3. dual cartridges: to use simply insert the cartridge into the application gun and start the plunger into the cylinders using light pressure on the trigger. next, remove the cartridge cap and expel a small amount of adhesive to be sure both sides are flowing evenly and freely. if automatic mixing of resin and hardener is desired, attach the mixing nozzle to the end of the cartridge and begin dispensing the
adhesive. for hand mixing, expel the desired amount of the adhesive and mix thoroughly. mix approximately 15 seconds after uniform color is obtained. bulk containers: mix thoroughly by weight or volume in the proportions specified in properties of uncured material section. mix vigorously approximately 15 seconds after uniform color is obtained.
4. for maximum bond strength apply adhesive evenly to both surfaces to be joined.
5. application to the substrates should be made within 60 minutes. larger quantities and/or higher temperatures will reduce this working time.
6. join the adhesive coated surfaces and allow to cure at 25°c (77°f) for 24 hours for high strength. heat up to 93°c (200°f), will speed curing.
7. keep parts from moving during cure. contact pressure is necessary. maximum shear strength is obtained with a 3-9 mil bond line.
8. excess uncured adhesive can be cleaned up with ketone type solvents.
包装规格:50ml/支
价格每月都有变化
如有不详细之处
请洽13391172323 或电邮至terun@aliyun.com
上海腾润经贸有限公司
张新东
13391172323
金都路208号