1.1  功能概述
  nasf6分解产物分析测试仪，提供了一种简单的sf6分解产物现场检测方法。使用过程中，连接到一个带压的充有sf6气体设备的气室中，让sf6气体以一定流速流过传感器，直接测量到sf6气体中主要分解产物的含量。
  传感器全部采用sf6专用传感器，长寿命设计，保证了测量结果的准确性和重现性。
  主要应用：故障定位，例行检测，局部放电监测，气体净化/过滤监测，故障高压接点检查，sf6分解产物检测，检查开关内分解产物的产生。
1.2  主要特点
●长寿命探测组件
●无需比色管、传感器直接测量
●优秀的准确性和重现性
●精确高，重复性好
●内置稳压阀和电子质量流量计
●超大液晶显示
●轻巧便携容易使用
●充电电池供电，交直流两用
●响应快，几乎无预热等候
●测量结果不受环境温度影响
1.3  技术指标
测量范围：so2：0～100ppm；h2s：0～100 ppm
灵敏度：so2：±0.1ppm；h2s：±0.1 ppm响应时间： 25s取   样：内置流量阀、流量计；
3.6米取样管和减压阀接头一只。工作温度：-10℃～+50℃电   源：直流：内置充电池，交流：220v／50hz；读   出：超大液晶图形化显示；尺   寸：258(mm)×240(mm)×88(mm)；重   量：2.6公斤；输出接口：usb1.2规范（可以选购配置）；取样流量： 0.01~1l/min，推荐流量：0.25l/min。
1.1 functional overview
nasf6 decomposition product analysis tester, provides a simple sf6 decompositionproductson-site detection method.in use, the sf6 gas is connected to a gas-filled sf6 gas chamber, allowing sf6 gas to flow through the sensor at a constant flow rate to directly measure the amountof maindecomposition products inthe sf6 gas.
all sensors use sf6-specific sensors, long-life design, to ensure the accuracyandreproducibility of measurementresults.
main applications: fault location, routine testing, partial discharge monitoring,gaspurification/ filtration monitoring, fault high voltage contact inspection, sf6 decomposition product detection, check the switch decomposition products.
1.2 main features
● long-life detection components
● no colorimetric tube, the sensor is directly measured
● excellent accuracy and reproducibility
● high precision, good repeatability
● built-in regulator and electronic mass flowmeter
● large lcd display
● lightweight and easy to use
● rechargeable battery-powered, ac-dc dual-use
● fast response, almost no warm-up waiting
● the measurement results are not affected by the ambient temperature
1.3 technical specifications
measuring range: so2: 0 ~ 100 ppm; h2s: 0 ~ 100 ppm
sensitivity: so2: ±0.1 ppm;h2s:±0.1ppm
response time: 25s
sampling: built-in flow valve, flow meter;
3.6 m sampling tube and a pressure reducing valve connector.
operating temperature: -10 ℃~ +50℃
power supply: dc: built-in rechargeable battery, ac: 220v / 50hz;
read out: large lcd graphic display;
size: 258 (mm) ×240 (mm)×88 (mm);
weight: 2.6 kg;
output interface: usb1.2 specification (optional configuration);
sampling flow: 0.01 ~ 1l / min, recommended flow: 0.25l / min.

---

南澳电气（武汉）有限公司
刘永强
15327206266
东湖高新技术开发区关山大道