长沙分类信息网-长沙新闻网

台湾IOI FWBX2-PCIE1XE220图像4路采集卡 LSI FW643 1394B视觉全

2020-4-30 23:26:33发布2次查看
品牌IOI型号FWBX2-PCIE1XE220
接口IEEE 1394质保一年


做项目剩下的,全新带包装,没用过,全新台湾ioi1394b采集卡
台湾ioi fwbx2-pcie1xe220图像4路采集卡lsi fw643 1394b视觉全新现货 
台湾ioi 1394b 800m采集卡fwbx4-pcie4xe120
4路1394b接口pci-e4x,4路实时
host adapters
fwbx4-pcie4xe120
quad ohci ieee 1394b (firewire 800) to pci express x4 gen2 host card
highlights
host bus: pcie x4 (4-lane) gen2 (20 gb/s)quad ohci 1.2 compliant ieee 1394b host controllersdesigned with late vg protectionfour independent external bilingual ieee std 1394b-2002 cable portso   supports bilingual plug port with jackscrew type 1394b cable
introduction
the fwbx4-pcie4xe120 is a quad ohci ieee 1394b (firewire 800) to pci express x4 gen2 host card.
fwbx4-pcie4xe120 is designed with two key components.
8-lane, 8-port pci express switch.ohci 1.2 compliant ieee 1394b single chip host controller (4pcs).multiplevcs (virtual channels) on the pci express link provide native support for qos (quality of service) transmission for real-time and multimedia applications in a standards-based framework, ensuring compatibility with current and future operating systems. active-state power management allows dynamic power management during periods of reduced network activity.
technical specifications
pci express:
standards complianto   pci express base specification, revision 2.0 (pci express base r2.0)o   pci express base specification, revision 2.0 erratao   backward-compatible with the pci express base specification, revision 1.1 (pci express base r1.1) and pci express base specification, revision 1.0a (pci express base r1.0a)o   pci bus power management interface specification, revision 1.2 (pci power mgmt. r1.2)o   microsoft vista®-complianto   supports access control serviceso   dynamic link-width controlo   dynamic serdes speed control
note: additional specifications, with which this product complies, are listed in supplemental documentation.high performanceo   non-blocking internal architectureo   full line rate on all portso   cut-thru latency – 190 ns for link widths of x4 to x1o   maximum payload size set to 256 or 128performancepaktmo   read pacingtm (intelligent bandwidth allocation)o   dual casttmo   dynamic buffer pool architecture for faster credit updatespci express power managemento   conventional pci-compatible link power management states – l0, l0s, l1, l2/l3 ready,and l3 (with vaux not supported)o   conventional pci-compatible device power management states – d0 and d3hoto   active state power management (aspm)quality of service (qos) supporto   two virtual channels (vc0 and vc1) per porto   eight traffic classes (tc[7:0]) per porto   weighted round-robin (wrr) port and virtual channel (vc) arbitration
ohci (open host controller interface)
enhanced with the ohci 1.2 draft specification for 1394b-2002 phy full operational compliance.ohci 1.0 backwards compatible. configurable via eeprom to operate in either ohci 1.0 or ohci 1.1 mode.8 kbyte isochronous transmit fifo.4 kbyte asynchronous transmit fifo.8 kbyte isochronous receive fifo.8 kbyte asynchronous receive fifo.dedicated asynchronous and isochronous descriptor-based dma engines.eight isochronous transmit contexts.eight isochronous receive contexts.supports parallel processing of incoming physical read and write requests.supports up to 48-bit addressing per ohci specification for the physical dma transfers.
1394b-2002 link
support for calculation and checking of the cyclic redundancy check (crc) on outgoing and incoming packetssupport for decoding the destination id of incoming 1394 packets to determine if an acknowledge is needed.cycle master and isochronous resource manager capabilitysupport for 1394a-2000 and 1394b acceleration features
1394b-2002 phy
ieee 1394b-2002 compliant ports supporting 1394b speeds of 800 mb/s and 400 mb/s while maintaining backward compatibility to ieee 1394a-2000 speeds of 100 mb/s, 200 mb/s, and 400 mb/s over 4.5 m copper.full support for ieee 1394a-2000 and 1394-1995 standard provisions for high-performance serial bus.registers to indicate power class modes.extended bias_handshake time for enhanced interoperability with camcorders.while unpowered and connected to the bus, the device does not drive tpbias on a connected port even if receiving incoming bias voltage on that port.no need for an external filter capacitor for pll.link-on as a part of the internal phy core-link interface.arbitrated short bus reset.ack-accelerated arbitration and fly-by concatenation.connection debounce.multispeed packet concatenation.phy pinging and remote phy access packets.port disable/suspend/resume.phy-link interface initialization and reset.support for the 1394a-2000 register set.fully interoperable with firewire® and i.link® implementation of ieee 1394-1995.cable power fail interrupt reported when voltage at tpcps pin falls below 7.5 v.separate cable bias and driver termination voltage supply for each port provided.
number of ports:
four external bilingual ports with screw holes for thumbscrew locking type 1394b cableo   ohci 4: one 1394b bilingual porto   ohci 3: one 1394b bilingual porto   ohci 2: one 1394b bilingual porto   ohci 1: one 1394b bilingual port
bus power connector:
either big ide 4-pin dc power connector or/and sata 15pin power connector
computer platform
computer with pci express slot (x4, x8, x16)
physical dimensions
130(d) x 99[120](h)mm
operating system requirements
windows 2000/xp/7/8/8.1 and windows server 2003mac os 10.4.8 or laterlinux 2.6.x
   正常情况下,发顺丰快递,不包含运费,谢谢合作!
   以上所标价格均为不含税价格,我司目前开具17%普票和17%增值税专用发票(如果贵司是一般纳税人,可以抵扣17%税点),我司所开具之发票均为国家税务局正规机打发票,支持验证!如需开具发票,需联系我司相关人员进行再次核实。
  以销售之日算起:我司产品按企业质量标准免费享受1年的保修期。超过保修期限的,我们只收取元器件成本费用服务。
  深圳市奋华科技有限公司是一家专注于机器视觉的高新科技企业。2013年成立,为了更符合公司产品发展需求,2016年更名为:深圳市深圳市奋华自动化科技有限公司,奋华专业从事机器视觉光源的研发、生产、销售,并提供整套机器视觉解决方案及服务。奋华以其实力雄厚、经验丰富的工程师队伍,强力打造机器视觉光源一流国际品牌! 在奋华,凝聚了一批追求卓越、勇于探索、敢于创新,并在机器视觉、自动化行业具有丰富经验的专业技术人员,组成了实力强大的技术团队和训练有素的管理、营销队伍。为公司在机器视觉光源的科研、开发提供了有力的保证,也为客户在视觉定位、光学检测、图像分析、图像测量等方面提供系统开发与集成等方面提供***优的解决方案。 公司目前主要光源产品有环形光源、同轴光源、面光源、条形光源、点光源、球积分光源、aoi检测专用光源、smt行业对位光源等多个系列。配套有数字式、模拟式光源控制器及增亮模块。除标准产品外,奋华有着一套完善的定制服务系统,为客户的设备量身定制光源,满足客户的特殊要求。 奋华公司拥有先进的生产设备和检测仪器,在光源的颜色、亮度、均匀度、寿命等技术指标上严密把关,时刻追踪国际***新技术动态,从而为光源的高品质、高性能提供了强有力的保障!奋华产品依靠其卓越的性能、优越的服务,广泛应用于电子、汽车、航空、医药、食品、机械等行业,在国内外客户中赢得了良好的声誉,并逐渐成为中国机器视觉光源领域的一支主力军. 奋华全体员工将共同努力,立足机器视觉行业,使本公司成为本行业***具实力的产品供应商和系统集成商。我们期待着更大规模、更深层次与国内外同行及社会各界朋友携手合作,互惠互利,共创辉煌! 科研 奋华视觉研发实力雄厚,公司拥有数十人的研发队伍。多项核心技术处于国内领先水平,品质 公司视产品品质为企业生命。对产品的设计、物料、工艺、制程、出货各个环节严格把关,确保出货产品的性能和质量; 为客户提供全面的售前、售中、售后支持和服务。 售前支持 : 专业的工程师队伍为您选型,售后服务 : 完善的售后服务体系.产品维护,产品升级,全面服务. 非标设计 : 灵活的非标设计流程能为您在10天之内提拱非标光源的设计. 方案提供 : 您只需将您的想法和需求告诉我们,我们为您提供专业的方案. 培训计划 : 如果您刚进入机器视觉行业,我们可以为您和您的队伍提供系统的机器视觉知识的培训.
深圳市奋华自动化科技有限公司
shenzhen fenhua-auto technology co., ltd.
地址:深圳市宝安区福永镇凤凰村东区222号
官方网站网址:www.fenhua-auto.cn
阿里巴巴网站:
https://shop1464714525679.1688.com/?spm=a2625d.7885740.0.0.kzr97q
联系人:高先生 刘小姐
电话:0755-23015665-801 传真:0755-23015665-802
qq客服:1027620478 1352556328
邮箱:james@fenhua-auto.cn
邮箱:james_gao@fenhua-auto.cn  

深圳市奋华自动化科技有限公司
高先生
13418972091
广东 深圳 宝安区 深圳市宝安区福永街道凤凰社区岺下路168号A栋310
该用户其它信息

推荐信息

长沙分类信息网-长沙新闻网
关于本站