日本爱安得and电子秤维修 传感器 gf-203a,gf-10002a,gf-303a,gf-403a,gf-603a,gf-6002a,日本and电子秤维修 gf-4002a,gf-6001a,gf-2002a,gf-10001a,gf-3002a,gf-1603a,gf-1003a
日本a&d电子天平维修and电子称维修显示屏  gx-203a,gx-10002a,gx-303a,gx-403a,gx-1003a,gx-6002a,gx-4002a
日本a&d电子天平维修 gx-10001a, gx-3002a, gx-603a, gx-1603a, gx-2002a,gx-6001a
□ enclose any ascii code string in single quotation marks. the character strings that can beoutput are alphanumeric characters and symbols. in addition, the single quotation marksthemselves are enclosed in two single quotation marks.example: to output the character string abc: 'abc'to output the character string 'abc': 'abc'□ to output the ascii control code, enter '# + 2 hexadecimal characters'.example: to output(04h): # 04□ spaces ($ sp),($ cr), and($ lf) can be repeated with numbers by adding '* +numbers (up to 2 characters)' after the command.example: to output 12 spaces: $ sp * 12to output 9's : $ cr * 9□ when sending a program command of two or more lines, adding '&' at the end of one line thebalance will judge the next line as the continuation of the program command.□ the balance sends an error code if there is a problem after receiving a program command andsends ancode if there is no problem.code is ascii 06h code.□ winct-ufc data communication software is available for inputting program commands 
日本a&d电子天平维修 记忆在“存储计数(单位质量表”。2.显示「p＊＊”的数量登记所选择的单位质量。3.按下并按住键切换到打印模式的改变单位质量注册号码。重新zerokeymodekeyprintkeycalkey4.多个单元可存储由注册单元注册具有不同质量。注※单位重量可通过读取“ｕｎ：ｍｍ”命令。mm（对应于p50与p01～01:50。）※读取单元输出的质量可以通过“uw？”命令可改变并且“uw？”命令。注※acai不能用于读取单元的质量
产品参数品牌：爱安得 and 艾安得 a&d型号：gf gx最小称量：mg最大称量：g适用范围：and电子秤维修 a&d电子天平维修

---

深圳进口天平售后服务维修中心
0755-15302766020
qq: 1771533651