概述milli-q® integral is a unique combination of optimized water purification and monitoring technologies. it allows, in a single device, both pure (type 2) and ultrapure (type 1) water to be produced......
milli-q integral 纯水系统 产品详情
规格water specificationsmilli-q®integral ultrapure water (type 1)resistivity at 25 °c1 18.2 mω•cm
toc2 ≤ 5 ppb
particulates (size > 0.22 μm)3 < 1 particulate/ml
bacteria3,4 < 0.01 cfu/ml
pyrogens (endotoxins)4 < 0.001 eu/ml
rnases4 < 1 pg/ml
dnases4 < 5 pg/ml
flow rate up to 2 l/min
1resistivity can also be displayed non-temperature-compensated as required by usp
2in the appropriate test conditions
3with millipak®final filter
4with biopak®polisher
these values are typical and may vary depending on the nature and concentration of contaminants in the feed water.
milli-q®integral pure water (type 2)resistivity at 25 °c1 typically 10-15 mω•cm
toc 0.22 µm)2 < 1 particulate/ml
bacteria2,3 < 0.1 cfu/ml
pyrogens (endotoxins)3 < 0.001 eu/ml
rnases3 < 0.01 ng/ml
dnases3 < 4 pg/µl
flow rate up to 2 l/min
1resistivity can also be displayed non-temperature-compensated as required by usp
2with millipak®final filter
3with biopak®polisher
feed waterfeed water quality potable tap water as described in us-epa, ep and who norms
feed water connection ½” gaz m
feed water pressure* 1 - 6 bar
feed water temperature 5 - 35 °c
* for pressure above 6 bar, a pressure regulator needs to be installed upstream of the system
system specificationsproduction unitdimensions (h x w x d) 500 x 332 x 484 mm (19.7 x 13.0 x 19.0 in)
operating weight 24 - 28 kg (52.9 - 61.7 lb)
electric power supply voltage 100 - 230 v +/- 10%
electric power supply frequency 50 - 60 hz +/- 10%
milli-q®integral main unit data connection ethernet (rj45)
q-pod®& e-pod®dispensersdimensions (h x d) 579 x 230 mm (22.8 x 9.0 in)
operating weight 4.7 kg (12.1 lb)
dispenser tubing length 0.8 m (31.5 in)
distance from production unit to q-pod® 2.9 m (9.5 ft)
electric power cable length 2.9 m (9.5 ft)
q-pod®data connection parallel port (25-pin d-sub)